This has been kicking me in the sitting muscles for a while recently, just wanted to see if anyone had any suggestions.
On a lighter note, there is a pretty good chance this is at least partially my fault. I replaced the scanner control board before I found out the read motor in the document feeder was acting badly in component test mode. So I guess it is at least kind of likely that the bad motor did in the new board.
On a lighter note, there is a pretty good chance this is at least partially my fault. I replaced the scanner control board before I found out the read motor in the document feeder was acting badly in component test mode. So I guess it is at least kind of likely that the bad motor did in the new board.