IRA 8095 Hole punch misaligne

Hey all,

I can't find anything in the SM about this. (Still searching)

How do I adjust or modify the hole puncher settings.

I am getting a misaligned hole set on my 8.5 * 11 paper when I do hole punching with finished.

it is off by about 1/4" from 1 end of paper to the other.

Thanks in advance for any assistance.


BTW there is NO error code being generated from this.

I do notice a slight crease in the paper next to where the hole punching is, not sure if this is normal or a symptom of the issue.

IKE