Hi guys, i stumbled across this forum while doing some research on our C3220. the machine was printing/scanning/copying just fine until an now ex employee messed with it. i know nothing about these machines other then what i have read over the last few days.
on to the problem...
if i connect the ethernet cable to the c1, then the patch cable into the NIC on the machine. i can not see the machine on my network, if i run my network cable to the NIC on the machine, i am able to see and ping the machine. also i am running it as DHCP.
now with it set up where i can ping and see the machine i am able to scan from it using my adobe pro, and i am able to add the network printer and send a print job to it, however somewhere between point A (my computer) and point B (the printer) the job is being lost. i am running the most current UFR II
any ideas would be much appreciated
on to the problem...
if i connect the ethernet cable to the c1, then the patch cable into the NIC on the machine. i can not see the machine on my network, if i run my network cable to the NIC on the machine, i am able to see and ping the machine. also i am running it as DHCP.
now with it set up where i can ping and see the machine i am able to scan from it using my adobe pro, and i am able to add the network printer and send a print job to it, however somewhere between point A (my computer) and point B (the printer) the job is being lost. i am running the most current UFR II
any ideas would be much appreciated