We have a brand new MPC305sp that we set up and then used for training. Part of the training involved removing the pcdus and the transfer unit.
This was all done with the power off and the power lead unplugged.
When all was put together, the machine boots, but when it must start the engine it reports that all pcdus are incorrecty installed.
There are no sc codes.
We have removed and re-installed all the pcdus and the itb several times, with no improvement.
Any ideas??
I am starting to think that we (inadvertently) damaged a board, as it seems to be a logic problem to me, as there is no visible loom damage or shorts.
This was all done with the power off and the power lead unplugged.
When all was put together, the machine boots, but when it must start the engine it reports that all pcdus are incorrecty installed.
There are no sc codes.
We have removed and re-installed all the pcdus and the itb several times, with no improvement.
Any ideas??
I am starting to think that we (inadvertently) damaged a board, as it seems to be a logic problem to me, as there is no visible loom damage or shorts.