This copier had been printing from network nicely until recent when it stopped receiving jobs and the monitor displays check network tcp/ip. Copying is normal and printing from USB is possible.
I tested the patch cable and even swapped it and found to be OK.
On checking further, I found the default key to be corrupted (however it wasn't displayed in the status monitor), I generated a new one and made it default, still couldn't connect.
I performed DC CON Clear, at this point on reboot it displayed "Default Key Corrupted', to which I once again generated a new one and made it default. I put new settings and tested but all was in vain.
So please, I need your advice.
Regards!
I tested the patch cable and even swapped it and found to be OK.
On checking further, I found the default key to be corrupted (however it wasn't displayed in the status monitor), I generated a new one and made it default, still couldn't connect.
I performed DC CON Clear, at this point on reboot it displayed "Default Key Corrupted', to which I once again generated a new one and made it default. I put new settings and tested but all was in vain.
So please, I need your advice.
Regards!